Independent Dual Extruder 3D Pritner Motherboard with TMC2208 Driver & Touch Screen

DMP Motherboard with TMC2208 Driver, Work quieter and more stable. Every Tenlog DMP Motherboard need 7 pcs TMC2208 Driver. This motherboard is pre-installed with 7pcs TMC2208 drivers, and with our newest Smart DMP 3D Printing Firmware.

Request A Quote

Product Details

The DMP motherboard contains seven TMC2208 drivers, Suitable for Hands 2, TL-D3 Pro, TL-D3S, TL-D5, TL-D6.

This kit comes with a touch screen and is equipped with a brand new UI.

Motherboard:

Input Voltage: 24V

Hot Bed Output Voltage: 24V

Support Power-loss Recover & Filament Runout Detection

SD Card Slot*1

USB Type-B Port*1

Tenlog 15Pin All-in-One Connector*2

Controllable Number of Motors: 7

Master Chip: ATmega2560

Whether to Pre-install Firmware: Yes, with Newest Version

Microcontroller	ATmega2560
Operating Voltage	5V
Input Voltage (recommended)	7-12V
Input Voltage (limit)	6-20V
Digital I/O Pins	54 (of which 15 provide PWM output)
Analog Input Pins	16
DC Current per I/O Pin	20 mA
DC Current for 3.3V Pin	50 mA
Flash Memory	256 KB of which 8 KB used by bootloader
SRAM	8 KB
EEPROM	4 KB
Clock Speed	16 MHz
LED_BUILTIN	13
Length	101.52 mm
Width	53.3 mm

Touch Screen:

4.3-inch 480*272 LCD Touch Screen OR

3.5-inch 480*320 LCD Touch Screen

Whether to Pre-install Firmware: Yes, with Newest UI

IDEX Firmware and UI from Tenlog

How to Upgrade Drivers to TMC2208 from A4988

1. Please make sure that the drive module and motherboard are placed in the direction shown in the figure below. Please note the direction of the screws in the red circle⭕.

How to Upgrade TMC2208 from A4988